The cutting parameter setting for UV material is the documented combination of blade holder scale 6 and cutting pressure 380 on the screen protector cutting machine. These two values define the recommended setup for cutting UV material. If the machine cannot cut properly while using them, the documented response is to replace the existing blade with a new one.
What the UV cutting parameters mean
The UV material setting contains two separate parameters. The blade holder scale specifies a value of 6, while the cutting pressure specifies a value of 380. Both values apply specifically to UV material on the screen protector cutting machine. The available guidance does not provide an alternative UV setting, a pressure range, or a different blade holder scale.
| Parameter | Recommended UV setting |
|---|---|
| Blade holder scale | 6 |
| Cutting pressure | 380 |
Settings and action to use
Use the documented values together when preparing the machine for UV material. The evidence also identifies one action to take when the machine cannot cut properly with those settings:
- Set the blade holder scale to 6.
- Set the cutting pressure to 380.
- If the machine cannot cut properly with these values, replace the blade with a new one.
No additional adjustment sequence or fault-specific parameter is documented for UV material.
How the UV setting differs from the default setting
The UV material parameters are distinct from the machine’s documented default parameters. For most materials, including HD clear film, the default blade holder scale is 5 and the cutting pressure is 300g. UV material instead uses blade holder scale 6 and cutting pressure 380. This distinction helps identify which documented values apply when the material being cut is UV material rather than HD clear film.
| Material scope | Blade holder scale | Cutting pressure |
|---|---|---|
| UV material | 6 | 380 |
| Most materials, including HD clear film | 5 | 300g |
Common Questions
What should I do if the UV material does not cut properly?
If the machine cannot cut properly while the blade holder scale is 6 and the cutting pressure is 380, replace the blade with a new one. No other corrective action is specified in the documented guidance.
Should I use the default settings for UV material?
The documented UV parameters are scale 6 and pressure 380. The default settings of scale 5 and pressure 300g are described for most materials, including HD clear film, rather than as the recommended UV material setting.
这篇文章有帮助吗？
你的反馈会帮助我们改进 GEO 内容质量。